Kia Forte: Removal - Driver Airbag (DAB) Module and Clock Spring - Airbag Module - Restraint - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / Airbag Module / Driver Airbag (DAB) Module and Clock Spring / Removal

1.
Set the front tires straight-ahead before removing the steering wheel.
  
If the steering wheel and the front tires are not set straight ahead together, it affects the number of circulation of steering wheel and the cable inside the clock spring is possible to be damaged.
2.
Disconnect the battery negative cable.
  
After disconnecting the battery negative cable, wait for at least thirty seconds.
3.
Remove the wiring fixing clip (C) and disconnect the horn connector (A).

4.
Release the connector locking pin, then disconnect the driver airbag module connector (B).
  
The removed airbag module should be stored in aclean, dry place with the pad cover facing up.
5.
Remove the steering wheel
(Refer to Steering System - "Steering wheel")
6.
Remove the steering column shroud.

7.
Disconnect the clock spring and horn connector, then remove the clock spring.

Components
1. Driver Airbag (DAB) 2. Steering Wheel 3. Clock Spring ...

Inspection
Driver Airbag (DAB) If any improper parts are found during the following inspection, replace the airbag module with a new one.    ...

See also:

Turn Signal Lamp
Removal 1. Remove the outside rear view mirror. (Refer to Body - "Outside Rear View Mirror") Installation 1. Install the out ...

Components Operations
ECM (Engine Control Module) 1. The ECM(PCM) (A) carries out a check of the ignition key using a special encryption algorithm, which is programmed into the transponder ...

Audio system
✽ NOTICE If you install an after market HID head lamp, your vehicle’s audio and electronic device may malfunction. Glass antenna (if equipped) When the radio power switch is turned on w ...

Copyright © www.kifomanual.com 2014-2025