Kia Optima Manuals

Kia Forte: Special Service Tools - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Special Service Tools

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Special Service Tools

Tool
(Number and Name)
 Illustration
 Use
09200-3N000
Engine support fixture (Beam)

Removal and installation of the transaxle.
Use this adapter (SST No. : 09200-4X000) with the supporter (SST No. : 09200-2S000).
※Permit operating with 09200-38001.
09200-2S000
Engine support fixture (Supporter)

Removal and installation of the transaxle.
Use this beam (SST No. : 09200-38001/3N000) with the supporter (SST No. : 09200-2S000) and adapter (SST No. : 09200-4X000).
09200-4X000
Engine support fixture (Adapter)

Removal and installation of the transaxle.
Use this beam (SST No. : 09200-38001/3N000) with the supporter (SST No. : 09200-2S000).
09452-26100
Oil seal installer

Installation of transaxle case oil seal.
[Using with handle (SST No.09231-H1100)]
09231-H1100
Bar

Installation of transaxle case oil seal.
[Using with oil seal installer (SST No.:09452-26100)]
09480-A3800
Inhibitor switch guide pin



※ Engine support fixture special tool assembly drawing

1. 09200-3N000(Main bar)
2. 09200-3N000(Sub bar)
3. 09200-3N000(Handle)
4. 09200-3N000(Stopper)
5. 09200-3N000(Bolt-1)
6. 09200-4X000 (Adapter)
7. 09200-2S000(Supporter)
8. 09200-2S000(Supporter)
9. 09200-3N000(Nut)
 10. 09200-3N000(Snap ring)
11. 09200-3N000(Sub fixture)
12. 09200-3N000(Stopper)
13. 09200-3N000(Nut)
14. 09200-2S000(Spacer)
15. 09200-2S000(Sub fixture)
16. 09200-2S000(Nut)
17. 09200-3N000(Pin)

Lubricants
Item  Specified lubricant  Quantity Transaxle fluid ATF SP-Ⅳ or equivalent  7.3L (1.93 U.S gal.,  7.71 U.S.qt., 6.42 Imp.qt ...

Automatic Transaxle
...

See also:

TJ Joint Installation
1. Wrap tape around the driveshaft spline (TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...

Removal
1. Turm ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the battery (A) and ECM (B). ...

ECM Terminal And Input/Output signal (M/T)
ECM Terminal Function Connector [CNG-MA] Pin No. Description Connected to 1 Ignition Coil (Cylinder #1) control output Ignition Co ...

Categories

Copyright www.kifomanual.com 2014-2026