Kia Forte: ETC (Electronic Throttle Control) System Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Remove the resonator and the air intake hose (Refer to “Intake
And Exhaust System” in EM group).
|
| 3. |
Disconnect the ETC module connector (A).
|
| 4. |
Disconnect the coolant hoses (B).
|
| 5. |
Remove the installation bolts (C), and then remove the ETC module
from the engine.
|
ETC (Electronic Throttle Control) System Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TP ...
ETC (Electronic Throttle Control) System Installation
•
Install the component with the specified torques.
•
...
See also:
SS-A Solenoid Valve(ON/OFF) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor ...
Replacement
1.
Uplift the vehicle with lift.
2.
Drain the manual transaxle oil after loosening the drain plug
(A).
3.
...
Circuit Diagram
...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright � www.kifomanual.com 2014-2026