Kia Forte: ETC (Electronic Throttle Control) System Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Inspection
Throttle Position Sensor (TPS)
| 1. |
Connect the GDS on the Data Link Connector (DLC).
|
| 2. |
Start the engine and measure the output voltage of TPS 1 and 2
at C.T. and W.O.T.
|
|||||||||||
ETC Motor
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the ETC module connector.
|
| 3. |
Measure resistance between the ETC module terminals 1 and 2.
|
| 4. |
Check that the resistance is within the specification.
|
ETC (Electronic Throttle Control) System Circuit Diagram
(M/T)
(A/T)
...
ETC (Electronic Throttle Control) System Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the resonator and the air intake hose (Refer to ...
See also:
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...
Air Ventilation Seat Unit Components Location
Components Location (1)
1. Seat back blower
2. Seat cushion blower
3. Air ventilation unit
4. Air ventilation switch
Components Location (2)
Components Locati ...
Shift Cable Removal
1.
Remove the floor console assembly.
(Refer to Body - "Floor Consol")
2.
Remove the air duct.
3.
...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026