Kia Forte: Crash Pad Lower Panel Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Crash Pad / Crash Pad Lower Panel Replacement

â€¢	Put on gloves to protect your hands.

â€¢	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

â€¢	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

â€¢	Take care not to bend or scratch the trim and panels.

1.	Using a screwdriver or remover, remove the crash pad side cover [LH] (A).

2.	After loosening the mounting screws, then remove the crash pad lower panel (A).

3.	Disconnect the diagnosis connector (A).

4.

Install in the reverse order of removal.

â€¢	Make sure the connector are connected in properly.

â€¢	Replace any damaged clips.

Crash Pad Lower Panel Component Location

1. Crash pad lower panel ...

Glove Box Housing Component Location

1. Glove box housing ...

See also:

Troubleshooting
Symptom Suspect area Engine will not start or hard to start Vapor hose damaged or disconnected Engine hard to start Malfunction of the Purge C ...

TPMS Receiver
1. Mode (1) Virgin State A. The receiver as a sole part is shipped in this state. ...

Windshield defrosting and defogging
WARNING - Windshield heating Do not use the or position during cooling operation in extremely humid weather to reduce the likelyhood of fog up. For maximum defrosting, set the tempe ...

Categories

Copyright © www.kifomanual.com 2014-2026