(5Door) |
|
|
1. |
Remove the rear wheel house trim.
(Refer to Interior Trim - "Rear Wheel House Trim")
|
2. |
Remove the rear transverse trim.
(Refer to Interior Trim - "Rear Transverse Trim")
|
3. |
After loosening the mounting clips and screw, then remove the
luggage side trim (A).
|
4. |
Disconnect the luggage lamp connector (A).
|
5. |
Install in the reverse order of removal.
|
Mode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control
actuator based on the signal of the A/C control unit. Pressing ...
Brake Booster Vacuum Pressure Sensor Inspection
1.
Check installation status of BBVPS and Vacuum hose or damage of
vacuum hose.
2.
Connect GDS to DLC (Data Link Cable).
...
Alternator On-vehicle Inpection
•
Check that the battery cables are connected to the correct
terminals.
...