Kia Forte: Removal - BCM (Body Control Module) - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / BCM (Body Control Module) / Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater & A/C control unit.
(Refer to Heating,Ventilation, Air Conditioning - "Heater & A/C controller unit(Manual))
(Refer to Heating,Ventilation, Air Conditioning - "Heater & A/C controller unit(DATC))
3.
Remove the floor console assembly.
4.
Remove the center lower cover (A) after loosening the screws.

5.
Remove the BCM unit. (in the order as below)
(1)
Disconnect the connectors (A) from the BCM unit.
(2)
Loosen the mounting nuts (B).
(3)
Remove the BCM unit (D) after disconnecting the connector (C) from the BCM unit.

Function
Function Description Input Output Front Washer & Wiper - IGN2 On & WasherS/W On and Off ...

Installation
1. Install the BCM unit. 2. Install the center lower cover. 3. Install the floor console assembly. ...

See also:

35R Clutch Control Solenoid Valve(35R/C_VFS) Specifications
Direct control VFS[35R/C] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42) Current value(mA) ...

Battery Vehicle parasitic current inspection
1. Turn the all electric devices OFF, and then turn the ignition switch OFF. 2. Close all doors except the engine hood, and then lock all d ...

Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

Copyright www.kifomanual.com 2014-2026