1. |
Remove the connector (A) from the wiper motor.
|
2. |
Attach the positive (+) lead from the battery to terminal 2 and
the negative (-) lead to terminal 5.
|
3. |
Check that the motor operates at low or high speed as below table.
|
Front Seat Belt Buckle Replacement
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Disconnect the front seat belt buckle conn ...
Manifold Absolute Pressure Sensor (MAPS) Installation
•
Install the component with the specified torques.
•
...
Tire replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band
across the tread. This shows there is less than 1/16 inch (1.6 mm) of tread left
on the tire. Replace the tire when ...