1. |
Disconnect the negative(-) battery terminal.
|
2. |
Carefully remove the lamp lens (A) from the room lamp with a flat-tip
screwdriver.
|
3. |
Replace the bulbs (A) and remove the screws if it is necessary.
|
4. |
Remove the room lamp assembly (A) after disconnecting the connector.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the vanity lamp (A) using a screwdriver or remover and
then disconnect the connector (B).
|
Power Window Switch Circuit Diagram
Driver Power Window Switch
[Driver/Passenger Safety]
[Driver Auto Down]
Passenger Power Window Switch
Rear Power Window Switch
...
Circuit Diagram
...
Auto Defogging Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the auto defogging connector.
3.
Verify that the auto defoggin ...