Kia Forte: Rear Combination Lamp Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Lighting System / Rear Combination Lamp Removal
Rear Combination Lamp (Outside)
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear combination lamp cover (A).
|
| 3. |
Remove the mounting nuts (4EA).
|
| 4. |
Remove the rear combination lamp (B) after disconnecting the connector
(A).
|
| 5. |
Replace turn signal lamp (A) and stop/tail lamp (B) by turning
the sockets counterclockwise.
|
Rear Combination Lamp (Inside)
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the trunk trim.
(Refer to Body - "Trunk Trim")
|
| 3. |
Remove the rear lamp assembly after removing the nuts (3EA) and
connector (A).
|
| 4. |
Replace the backup lamp (A) and stop lamp (B) by turning the sockets
counterclockwise.
[General Type]
[LED Type]
|
High Mounted Stop Lamp Installation
[2 Door]
1.
Install the high mounted stop lamp assembly.
2.
Install the roof trim assembly.
[4 Door]
1.
...
Rear Combination Lamp Installation
1.
Install the rear combination lamp (Inside) assembly.
2.
Install the rear combination lamp (outside) assembly.
...
See also:
Scheduled maintenance service
Follow the Normal Maintenance Schedule if the vehicle is usually operated where
none of the following conditions apply. If any of the following conditions apply,
follow the Maintenance Under Severe ...
Installation
1.
Install the multifunction switch.
2.
Install the clock spring.
3.
Install the steering column upper and lowe ...
Fuel Tank Pressure Sensor (FTPS) Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification:
...
Copyright © www.kifomanual.com 2014-2025