1. |
Disconnect the ignition switch connector (B) and key warning switch
connector (A) from the steering column.
|
2. |
Check for continuity between the terminals.
|
3. |
If continuity is not specified, replace the switch.
|
Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
Wear, rattle or scoring of wheel b ...
Control Shaft Complete Installation
1.
Install in the reverse order of removal.
•
...
Hood Latch Replacement
1.
Disconnect the hood latch connector (A).
2.
Remove the hood latch assembly (A) mounting bolts.
Tightening ...