1. |
Disconnect the negative (-) battery terminal.
|
2. |
Disconnect the evaporator temperature sensor connector (A).
|
3. |
Remove the evaporator temperature sensor (B) by pulling it out
after rotating it 90° in a counterclockwise direction.
|
4. |
Install in the reverse order of removal.
|
Component Location
[Engine Room]
1. Receiver Drier
2. Condenser
3. Ambient Temperature Sensor
4. Compressor
5. Discharge Hose
6. Suction & Liquid Tube Assembly
7. Servic ...
General Information
1.
Check & Change intervals
Check & Replenishment
Change
Capacity
Oil specification
...
Fuse/relay panel description
Inside the fuse/relay panel covers, you can find the fuse/relay label describing
fuse/relay name and capacity.
✽ NOTICE
Not all fuse panel descriptions in this manual may be applicable t ...