Kia Optima Manuals

Kia Forte: Starter Relay Inspection - Starting System - Engine Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Starter Relay Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Starting System / Starter Relay Inspection

1.
Disconnect the battery negative terminal.
2.
Remove the fuse box cover.
3.
Remove the starter relay (A).
4.
Using an ohmmeter, check that there is continuity between each terminal.
Terminal
 Value
 Measure
30 - 87
 1MΩ or Higher
 If there is continuity, replace the relay.
85 - 86
 continuity
 If there is no continuity, replace the relay.

5.
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.
Terminal
 Continuity
30 - 87
 Below 1Ω
85 - 86
 Apply 12V

6.
If there is no continuity, replace the starter relay.
7.
Install the starter relay.
8.
Install the fuse box cover.
Starter Cleaning
1. Do not immerse parts in cleaning solvent. Immersing the yoke assembly and/or armature will damage the insulation wipe these parts with a cloth only. ...

Cruise Control System
...

See also:

Hazard Lamp Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the center fascia panel. (Refer to Body - "Center Fascia Panel") ...

Body Panel Gaps
...

Front Oil Seal Replacement
1. Remove the crankshaft damper pulley. (Refer to Timing System - "Crankshaft Damper Pulley") 2. Remove the front oil seal (A) ...

Categories

Copyright � www.kifomanual.com 2014-2026