Kia Forte: Variable Charge Motion Actuator (VCMA) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Variable Charge Motion Actuator (VCMA) Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the VCMA connector (A).
|
| 3. |
Remove the VCMA (A) after removing 3 installation bolts.
|
Variable Charge Motion Actuator (VCMA) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the VCMA connector.
3.
Check that the VCMA is not stuck by foreign ...
Variable Charge Motion Actuator (VCMA) Installation
•
Install the component with the specified torques.
•
...
See also:
ETC (Electronic Throttle Control) System Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TP ...
Front Seat Shield Outer Cover Component Location
1. Front seat shield outer cover
...
Rear Door Outside Handle Component Location
(4Door, 5Door)
1. Rear door outside handle
...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026