Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Clutch System / Clutch Switch / Installation

1.	Install in the reverse order of removal.

2.

Adjust the clutch switch.

(1)

Adjust the gab by rotating the adjust nut (A) to satisfy the standard gap range.

Standard gap range:

0.5 ~ 1.0 mm (0.0197 ~ 0.0394 in.)

(2)

Tighten the nut (B) with the specified torque.

Tightening torque:

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Removal

1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the smart junction box (Refer to Body Electri ...

Ignition Lock Switch

...

See also:

Troubleshooting
Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel b ...

Hood Insulator Pad Replacement
1. Using a clip remover, detach the clips, and remove the hood insulator pad (A). ...

Removal
1. Remove the transaxle assembly. (Refer to Manual Transaxle System - " Manual Transaxle") 2. Remove the concentric slave cyl ...

Categories

Copyright © www.kifomanual.com 2014-2026