Kia Forte: Transaxle Oil Temperature Sensor Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Oil Temperature Sensor Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the Solenoid valve connector.
|
| 3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 4. |
Check that the resistance is within the specification.
(Refer to Transaxle Oil Temperature Sensor - "Specifications")
|
Transaxle Oil Temperature Sensor Removal
1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - &qu ...
See also:
Rear Glass Defogger Switch Replacement
1.
Remove the center fascia panel.
(Refer to Body - "Center Fascia Panel")
2.
Remove the cluster fascia panel.
(Refer ...
Audio system
✽ NOTICE
If you install an after market HID head lamp, your vehicle’s audio and electronic
device may malfunction.
Glass antenna (if equipped)
When the radio power switch is turned on ...
Seat Heater (Non-Air Ventilation) Circuit Diagram
※ The cushion heater and back cushion are connected with wiring. ...
Copyright © www.kifomanual.com 2014-2025