Kia Forte: Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the Solenoid valve connector.
|
| 3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 4. |
Check that the resistance is within the specification.
(Refer to Overdrive Clutch Control Solenoid Valve - "Specifications")
|
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...
See also:
Start/Stop Button Removal
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center garnish [LH]
(A).
...
Manual transaxle operation
The manual transaxle has 6 forward gears.
This shift pattern is imprinted on the shift knob. The transaxle is fully synchronized
in all forward gears so shifting to either a higher or a lower ge ...
Engine Control Module (ECM) Removal
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026