Kia Forte: Rear Coil Spring Replacement - Rear Suspension System - Suspension System - Kia Forte TD 2014-2018 Service ManualKia Forte: Rear Coil Spring Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Suspension System / Rear Suspension System / Rear Coil Spring Replacement

1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub.

Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

  
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).
3.
Remove the rear shock absorber (A) from the frame by loosening the bolt & nut.

Tightening torque :
98.1 ~ 117.7N.m(10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

4.
Installation is the reverse of removal.
5.
Check the rear alignment.
(Refer to Rear Suspension System - "Rear Alignment")
Rear Coil Spring Components
1. Spring upper pad 2. Spring 3. Spring lower pad ...

Rear Coil Spring Inspection
1. Check the coil spring for crack and deformation. 2. Check the coil spring pad for damage and deformation. ...

See also:

Checking the engine oil level
1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...

Installation
1. Install in the reverse order of removal.    A. ...

Knock Sensor (KS) Description
Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. Whe ...

Copyright www.kifomanual.com 2014-2026