Kia Forte: Removal - Master Cylinder - Brake System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Brake System / Master Cylinder / Removal

1.
Turm ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the battery (A) and ECM (B).

3.
Disconnect the brake fluid level switch connector (A), and remove the reservoir cap.

4.
Remove the brake fluid from the master cylinder reservoir with a syringe.
  
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
5.
Disconnect the brake tube (A) from the master cylinder by loosening the tube flare nut.

Tightening torque:
ABS : 12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
ESC : 18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)

6.
Remove the clutch hose (B). [MT only]
7.
Remove the master cylinder (B) from the brake booster after loosening the mounting nuts (A).

Tightening torque:
9.8 ~ 15.7 N.m (1.0 ~ 1.6 kgf.m, 7.2 ~ 11.2 lb-ft)

Master Cylinder
Components 1. Reservoir cap 2. Reservoir 3. Grommet 4. Master cylinder ...

Installation
1. Install in the reverse order of removal. 2. After installation, bleed the brake system. (Refer to Brake system bleeding) ...

See also:

Windshield Wiper-Washer Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to Steering System - "Steering Wheel") ...

Trunk Lid Latch Component Location
(4Door) 1. Trunk lid latch assembly (2Door) 1. Trunk lid latch assembly ...

Auto Light Sensor Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the auto light sensor (A) from crash pad upper side by using screw (-) driver. ...

Copyright © www.kifomanual.com 2014-2024