Kia Forte: Hands Free Switch Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Hands Free System / Hands Free Switch Installation

1.	Reassemble the steering wheel remote control switch after connecting the connector.

2.

Reassemble the driver airbag module.

Make sure the audio remote control switch and the airbag module connectors are plugged in properly.

Hands Free Switch Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the driver airbag module. (Refer to Restraint - "Driver Airbag (DAB) Mod ...

Hands Free Mic Inspection

1. Disconnect the negative(-) battery terminal. 2. Remove the handsfree mic (A) after disconnect the connector from roof trim. ...

See also:

Blower Resistor Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the blower resistor connector (A) and then remove the blower resistor (B) af ...

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Low Panal") ...

Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning directio ...

Categories

Copyright © www.kifomanual.com 2014-2026