Connector Pin Function |
Connector |
No. |
Description |
Connector |
No. |
Description |
A |
1 |
Illumination (+) (Tail) |
A |
25 |
Humidity (PVM) |
2 |
Sensor REF (+5V) |
26 |
Ambient sensor (+) |
||
3 |
Defog actuator (Open) |
27 |
In-car sensor (+) |
||
4 |
Defog actuator (Close) |
28 |
Evaporator sensor (+) |
||
5 |
Mode actuator (Vent) |
29 |
ECV (+) |
||
6 |
Mode actuator (Defrost) |
30 |
ECV (-) |
||
7 |
Mode actuator feedback |
31 |
Photo sensor (-) - Left |
||
8 |
Intake actuator (Fresh) |
32 |
Photo sensor (-) - Right |
||
9 |
Intake actuator (Recirculation) |
33 |
HTD |
||
10 |
Intake actuator feedback |
34 |
Rear defog switch |
||
11 |
Temperature actuator (Cool) - Driver |
35 |
K-Line |
||
12 |
Temperature actuator (Warm) - Driver |
36 |
PTC relay (Gasoline PTC only) |
||
13 |
Temperature actuator feedback - Driver |
37 |
- |
||
14 |
Temperature actuator (Cool) - Passenger |
38 |
ISG DC |
||
15 |
Temperature actuator (Warm) - Passenger |
39 |
- |
||
16 |
Temperature actuator feedback - Passenger |
40 |
Sensor ground |
||
17 |
C_CAN (High) |
B |
1 |
Ground |
|
18 |
C_CAN (Low) |
2 |
IGN 2 |
||
19 |
Detent OUT (+) |
3 |
Blower motor (+) |
||
20 |
Illumination (-) (Rheostat) |
4 |
Ground |
||
21 |
Ion signal |
5 |
FET (Gate) |
||
22 |
Clean signal |
6 |
FET (Drain feedback) |
||
23 |
Ionizer diagnosis |
7 |
IGN 1 |
||
24 |
Defog actuator feedback |
8 |
Battery (+) |
Power Door Lock Actuators Inspection
Front Door Lock Module Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front d ...
In-car Sensor (DATC only) Inspection
1.
Turn the ignition switch ON.
2.
Blow air with changing temperature into the in-car sensor air
inlet. Measure the sensor resistance betwe ...
Drive Belt Tensioner Components
1. Alternator brace
2. Adjust nut
...