Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Sensor / Installation

Sensor Fit

â€¢	Handle the sensor with care.

â€¢	Avoid lubricant contact.

â€¢	Ensure that the wheel to be fitted is designed for sensor mount. There should normally be a mark to indicate this.

â€¢	Ensure that the valve hole and mating face of the wheel are clean.

1.	Slide the sensor-valve unit through the valve hole of the rim. Hold the sensor against the rim and the rubber grommet against the sealing surface.

2.	Insert the nut over the valve stem and then tighten the nut.

Continue to tightening the nut until contact with the rim and then tighten to 2.4 ~ 3.0Nm.

-	Tighten slowly with quarter turn steps until the final torque is reached.

-	Do not exceed allowed torque.

-	Do not use electric or pneumatic tools.

Check that the sensor is firmly attached to the rim.

Risk of damage during the tire installation/ removal if the sensor is not firmly attached to the rim.

5.	Carry out inflation / pressure correction and then fit valve cap.

6.	Install the tire. (Refer to "Tire Installation")

7.	In the case of TPMS sensor failure, TPMS sensor needs learning. Faulty sensor is replaced new units, conduct learning of TPMS sensors.

Removal

Handle the sensor with care. 1. Remove the tire. (Refer to Tire/Wheels - "Tire& ...

Diagnosis procedure by using diagnostic device

As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

Kia Forte: Installation

Removal

Diagnosis procedure by using diagnostic device

See also:

Categories