When heavy rear components such as suspension, fuel tank, spare tire,
tailgate and trunk lid are to be removed, place additional weight in
the luggage area before hoisting. When substantial weight is removed
from the rear of the vehicle, the center of gravity may change and can
cause the vehicle to tip forward on the hoist.
|
|
1. |
Place the lift blocks under the support points as shown in the illustration.
|
2. |
Raise the hoist a few inches (centimeters) and rock the vehicle to be
sure it is firmly supported.
|
3. |
Raise the hoist to full height to inspect the lift points for secure
support.
|
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty
seconds.
...
Crankshaft Components
1. Crankshaft upper bearing
2. Crankshaft thrust bearing
3. Crankshaft
4. Crankshaft lower bearing
5. Crankshaft position sensor (CKPS) wheel
6. Lower crankcase
7. Gas ...
Rear Wheel House Trim Replacement
(4Door)
•
Put on gloves to protect your hands.
...