Kia Forte: Purge Control Solenoid Valve (PCSV) Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV) Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the purge control solenoid valve connector (A).

3.	Disconnect the vapor hoses (B) from the purge control solenoid valve.

4.	Remove the valve (C) from the surge tank after pulling it.

Purge Control Solenoid Valve (PCSV) Inspection

1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV termi ...

Purge Control Solenoid Valve (PCSV) Installation

• Install the component with the specified torques. • ...

See also:

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Circuit Diagram
...

Audio Unit Removal
• When prying with a flat-tip screwdriver, wrap it with protective tape, and apply pro ...

Component Location
1. Hood switch 2. Burglar horn 3. BCM and RF antenna 4. Key warning switch 5. Front door switch 6. Front door lock actuator & switch 7. Rear door lock actuator &am ...

Categories

Copyright � www.kifomanual.com 2014-2026