Kia Forte: Mode Control Actuator Replacement
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Heater / Mode Control Actuator Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body -"Crash Pad Lower Panel")
|
| 3. |
Remove the driver's side shower duct by loosening the screw.
|
| 4. |
Disconnect the connector (A) and then remove the mode control
actuator (B) after loosening the mounting screws.
|
| 5. |
Install in the reverse order of removal.
|
Mode Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode con ...
Auto Defogging Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the auto defogging connector.
3.
Verify that the auto defoggin ...
See also:
Engine And Transaxle Assembly Installation
Installation is in the reverse order of removal.
Perform the following :
•
Adjust shift cable.
•
Adjust throttle cable.
•
...
IMS Control Switch Circuit diagram
...
Room lamp
To turn the room lamp ON or OFF, push the switch.
If your vehicle is not equipped with a map lamp, the room lamp will also turn
on or off as follows.
The room lamp comes on when a door is opene ...
Copyright © www.kifomanual.com 2014-2025