Kia Optima Manuals

Kia Forte: Cooling Fan Removal and Installation - Cooling System - Engine Mechanical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Cooling Fan Removal and Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cooling System / Cooling Fan Removal and Installation

Cooling fan assembly
1.
Disconnect the battery "-" terminal.
2.
Remove the air duct and air cleaner assembly.
(Refer to Intake And Exhaust System - "Air Cleaner)
3.
Disconnect the over flow hose (A) from the filler neck.

4.
Loosen the filler neck assembly mounting bolts (A).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

5.
Disconnect the fan motor connector (A).

6.
Loosen the variable Intake solenoid (VIS) actuator mounting bolts (A).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

7.
Detach the variable intake solenoid (VIS) valve & bracket after unfastening the mounting bolt (A).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

8.
Disconnect the crankshaft position sensor (CKPS) connector (A) and the front connector (B).
9.
Remove the cooling fan (A).
Tightening torque:
4.9 ~ 7.8 N.m (0.5 ~ 0.8 kgf.m, 3.6 ~ 5.8 lb-ft)

Resistor
1.
Disconnect the wire harness connector (A) and the fan motor connector (B).

2.
Remove the resistor (A) from the cooling fan shroud.
Tightening torque :
1.8 ~ 2.5 N.m (0.18 ~ 0.25 kgf.m, 1.3 ~ 1.8 lb-ft)

3.
Install in the reverse order of removal.
Cooling Fan Circuit Diagram
...

Cooling Fan Disassembly
1. Remove the cooling fan (A) from the cooling fan assembly. 2. Disconnect the fan motor connector (A) from the resistor. ...

See also:

SS-B Solenoid Valve(ON/OFF) Description
Shift Solenoid(SS) Valve-B is attached to the valve body and is an on/off solenoid valve that is used to change gears. Shift Solenoid(SS) Valve-B is installed at valve body. ...

Front Wiper Motor Inspection
Speed Operation Check 1. Remove the connector (A) from the wiper motor. 2. Attach the positive (+) lead from the battery to terminal ...

Fuel Tank Pressure Sensor (FTPS) Specification
Pressure [kPa (kgf/cm², in H2O) Output Voltage (V) -6.67 (-0.068, -26.8) 0.5 0 2.5 +6.67 (0.068, 26.8) 4.5 ...

Categories

Copyright www.kifomanual.com 2014-2026