Kia Optima Manuals

Kia Forte: TJ Joint Installation - Driveshaft Assembly - Driveshaft and axle - Kia Forte TD 2014-2018 Service ManualKia Forte: TJ Joint Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Driveshaft and axle / Driveshaft Assembly / TJ Joint Installation

1.
Wrap tape around the driveshaft spline (TJ) to prevent damage to the boot.
2.
Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and snap ring (B) on the driveshaft splines (C).
3.
Add specified grease to the joint boot as much as it was wiped away at inspection.
4.
Install the both boot band.
5.
To control the air in the TJ boot, keep the specified distance between the boot bands when they are tightened.
Engine
 TM
 Distance (L) mm(in.)
LH side
 RH side
Nu 1.8 MPI
 6 M/T
 542.6(21.3622)
 829.0(32.6614)
Nu 1.8 MPI
 6 A/T
 522.0(20.5630)
 815.0(32.0984)
Nu 2.0GDI
 6 M/T
 542.6(21.3622)
 829.0(32.6614)
Nu 2.0GDI
 6 A/T
 522.0(20.5630)
 815.3(32.0984)
Gamma 1.6 TGDI
 6 M/T
 530.6(20.8898)
 517.9(20.3898)
Gamma 1.6 TGDI
 6 A/T
 522.1(20.5551)
 537.8(20.1732)

6.
Using the SST(09495-3K000), secure the TJ boot bands.
Clearance (A): 2.0 mm (0.0787 in.) or less

7.
Install the Front Driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
8.
Check the front alignment.
(Refer to Suspension System - "Front Alignment")
TJ Joint Inspection
1. Check the spider assembly for roller rotation, wear or corrosion. 2. Check the groove inside the joint case for wear or corrosion ...

Dynamic Damper Components
1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 1 ...

See also:

Windshield Wiper-Washer Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to Steering System - "Steering Wheel") ...

Description
System Overview The System offers the following features: - Human machine interface through a 1-stage button, for terminal switching and engine start. ...

Alternator Description
The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal. In addition, the charging voltage ...

Categories

Copyright www.kifomanual.com 2014-2026