Kia Optima Manuals

Kia Forte: Diagnosis procedure by using diagnostic device - TPMS Sensor - Tire Pressure Monitoring System - Suspension System - Kia Forte TD 2014-2018 Service ManualKia Forte: Diagnosis procedure by using diagnostic device

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Sensor / Diagnosis procedure by using diagnostic device

As manual for diagnosis methods by using diagnosis device, the main contents are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower of driver side crash pad to self-diagnosis device, and then turn the self-diagnosis device after key is ON.
2.
Select the "vehicle model" and "TPMS" on GDS vehicle selection screen, then select OK.
[Register Sensor initialization]

[Register Sensor function description]

[Preparation phase sensor measurements]

[Sensor register method 1]

[Sensor register method 2]

[Sensor register method 3]

[Sensor register method 4]

[Sensor register method 5]

  
•
Write ID Read ID and be sure to check are the same.
•
After registering successfully sensor "Sensor Wireless Information" by the execution determines whether the sensor is working properly.
[Sensor Status initialization]

[Sensor function description]

[Preparation phase sensor measurements]

  
•
In North America, the cable is measured separately.
•
In Domestic/General(European) area, the cable is measured without separation.
[Sensor measurements 1]

[Sensor measurements 2]

[Sensor Status]

  
•
Each entry must check whether each sensor normal.
•
After replacing the tires or sensors, check the status of sensor is working properly after sensor registration process.
Installation
Sensor Fit    • Handle the sensor with care. • ...

TPMS Receiver
1. Mode (1) Virgin State A. The receiver as a sole part is shipped in this state. ...

See also:

Torque Converter Control Solenoid Valve (T/CON_VFS) Description
Torque converter control solenoid valve (T/CON_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the torque converter. ...

Removal
1. Remove the transaxle assembly. (Refer to Manual Transaxle System - " Manual Transaxle") 2. Remove the concentric slave cyl ...

Line Pressure Control Solenoid Valve Specifications
Direct control VFS[Line Pressure] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42) Current val ...

Categories

Copyright www.kifomanual.com 2014-2026