Kia Forte: Seat Belt Buckle Sensor (BS)

The SRSCM shall monitor the status of the driver and passenger seat belt buckle. The SRSCM provides one pin each for the driver and passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SRSCM, and uses chassis ground for the signal return. The buckle status shall modify the SRSCM deployment. If the buckle status is unbuckled, the corresponding pretensioner will not be deactivated.

Installation

Pressure Side Impact Sensor 1. Install the new pressure side impact sensor with the screws (B) then connect the pressure side impact sensor connector (A). ...

Components

...

See also:

TJ Joint Installation
1. Wrap tape around the driveshaft spline (TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...

Description
The Evaporative Emission Control System prevents fuel vapor stored in fuel tank from vaporizing into the atmosphere. When the fuel evaporates in the fuel tank, the vapor passes through vent h ...

Removal
1. Remove the front wheel & tire. Tightening torque: 88.3 ~107.9 N.m (9.0 ~11.0 kgf.m, 65.1 ~79.6 lb-ft) ...