Kia Optima Manuals

Kia Forte: Inspection - Brake Pedal - Brake System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Brake System / Brake Pedal / Inspection

1.
Check the bushing for wear.
2.
Check the brake pedal for bending or twisting.
3.
Check the brake pedal return spring for damage.
4.
Check the stop lamp switch.
(1)
Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in and when it is released.
(2)
The stop lamp switch is in good condition if there is no continuity when plunger(A) is pushed.
Removal
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to Body - & ...

Installation
1. Pre-tighten the bracket fixing bolt (A) in dash panel. 2. Install the brake booster and brake pedal member fixing nuts (A) secur ...

See also:

Auto Light Sensor Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the auto light sensor (A) from crash pad upper side by using screw (-) driver. ...

Power windows (if equipped)
The ignition switch must be in the ON position for power windows to operate. Each door has a power window switch that controls the door’s window. The driver has a power window lock switch which ca ...

Temperature Control Actuator Replacement
[Driver's side] 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body -& ...

Categories

Copyright www.kifomanual.com 2014-2026