Kia Forte: Inspection
If any of the following conditions occur, WCS reset and accuracy check
should be performed.
| • |
The WCS ECU or any of the sensors is replaced.
|
| • |
The vehicle is brought to the repair shop due to an accident or
a crash even though the severity seems to be minor.
|
| • |
The telltale lamp is not illuminated when thepassenger seat is
not occupied.
|
| • |
The telltale lamp is delayed more than 10 seconds to be turned
off when an adult passenger seats in.
|
| • |
The passenger seat is removed from the vehicle and reassembled.
|
| • |
Any accessories (side table, seatback table and seat cover, etc)
are replaced or installed.
|
| • |
The passenger seat is interference with the folded rear seat.
|
If Same problems is continued, WCS must be replaced after WCS Reset and
accuracy check.
Components
...
Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the front passenger seat ass ...
See also:
Front Driveshaft Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A ...
Timing Chain Cover Components
1. Timing chain cover
2. Service plug bolt & gasket
...
Troubleshooting
Symptom
Suspect Area
Remedy (Refer to page)
Water leaks from sunroof
Dirt accumulated in drain tube
Clear dirt inside of drain
Clogged drai ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026