Kia Optima Manuals

Kia Forte: Removal - Weight Classification System (WCS) - SRSCM - Restraint - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / SRSCM / Weight Classification System (WCS) / Removal

1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front passenger seat assembly.
(Refer to Body - "Front seat")
3.
Remove the seat track assembly.
(Refer to Body - "Front seat")
  
•
There are several DTC cases, please check below status.
Case A
 B1763 OCS ECU Defect
Case B
 B1323 OCS Sensor Defect
Case C
 B1319 OCS Required Weight Check
Case D
 B1697 ACU Communication error

•
Case A. B. Remove the seat track assembly of the front passenger seat . After replacing, perform WCS reset and DTC clear.
•
Case C. Perform WCS reset and accuracy check, if accuracy check result is accepted and DTC is historic, WCS can be re-used.
•
Case D. Check wirings and connectors. If there is no DTC after WCS reset and DTC clear, WCS can be re-used.
Inspection
If any of the following conditions occur, WCS reset and accuracy check should be performed. • The WCS ECU or any of the sensors is replaced. • ...

Installation
   WCS(Weight Classification System) is utilizing a robust weight measuring technology. Thus, if any of the following condi ...

See also:

Blower Unit Component Location
...

Transaxle Oil Temperature Sensor Inspection
1. Turn ignition switch OFF. 2. Disconnect the Solenoid valve connector. 3. Measure resistance between sensor ...

Installation
1. Install in the reverse order of removal. 2. After be equipped, perform bleeding air procedure in clutch release cylinder after pouring t ...

Categories

Copyright www.kifomanual.com 2014-2026