Kia Forte: Adjustment
| Stop lamp switch clearance adjustment |
If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~
0.08in), conform to below.
| 1. |
Disconnect the stop lamp switch connector (A).
|
| 2. |
Pull the locking plate (A) as indicated by the arrow.
|
| 3. |
Turn stop lamp switch 45° counterclockwise and remove it.
|
| 4. |
Fix the brake pedal arm and insert fully the stop lamp switch
as hiding contact part.
|
| 5. |
After inserting, turn the stop switch 45° clockwise, and then
assemble locking plate by pushing.
|
| 6. |
Confirm the gap between stop lamp switch and bracket.
|
| 7. |
Connect the stop lamp switch connector.
|
Installation
1.
Pre-tighten the bracket fixing bolt (A) in dash panel.
2.
Install the brake booster and brake pedal member fixing nuts (A)
secur ...
Front Disc Brake
Components
1. Guide rod bolt
2. Bleed screw
3. Caliper carrier
4. Caliper body
5. Inner pad shim
6. Brake pad
7. Pad retainer
...
See also:
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the mul ...
Measurement Method
Projected Dimensions
1.
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions ...
Sunroof open warning (if equipped)
If the driver removes the ignition key (smart key: turns off the engine) and
opens the driver-side door when the sunroof is not fully closed, the warning chime
will sound for a few seconds and a ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026