Kia Forte: Inspection - Vacuum Pump - Brake System - Brake System - Kia Forte TD 2014-2019 Service ManualKia Forte: Inspection

Second generation YD (2014-2019) / Kia Forte TD 2014-2019 Service Manual / Brake System / Brake System / Vacuum Pump / Inspection

1.
Check the brake warning lamp in the IGN ON position.
  
Brake warning lamp is ON as below conditions.
1.
Brake warning lamp is ON as below conditions.
2.
Low brake fluid level warning
3.
Low brake vacuum pressure warning
-
Vacuum pump is abnormal condition
-
Vacuum pump CAN communication is abnormal condition
2.
Check that the brake warning lamp is ON after the release the parking brake with a sufficient brake fluid level.
If the brake warning lamp is ON, check the below points.
(1)
Is the brake warning lamp ON within 5 seconds after IGN ON?

▶ Reinstall the vacuum pump connector after removing it. And if the brake warning lamp is ON within 5 seconds after IGN ON, replace the vacuum pump.

▶ Check the 2).

(2)
Is the brake warning lamp ON within 45~55 seconds?

▶ Brake vacuum switch is normal condition.

▶ Check the 3).

(3)
Is the brake warning lamp ON within 15~30 seconds after removing the vacuum hose from the brake booster?

▶ Replace the vacuum pump

▶ Vacuum pump is normal condition

Removal
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the vacuum pump connector (A). ...

Installation
1. Install in the reverse order of removal. 2. Tighten the vacuum pump mounting bolts to the specified torque. ...

See also:

Parking Assist Sensor Component
...

Front Door Outside Handle Replacement
(4Door, 5Door, 2Door) 1. Remove the front door module. (Refer to Front Door - "Front Door Module") 2. Disconnect ...

Certification label
The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross V ...

Copyright © www.kifomanual.com 2014-2019