Kia Forte: Installation - Vacuum Pump - Brake System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Brake System / Vacuum Pump / Installation

1.
Install in the reverse order of removal.
2.
Tighten the vacuum pump mounting bolts to the specified torque.
Inspection
1. Check the brake warning lamp in the IGN ON position.    Brake warnin ...

Master Cylinder
Components 1. Reservoir cap 2. Reservoir 3. Grommet 4. Master cylinder ...

See also:

CVVT Oil Control Valve (OCV) Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the CVVT oil control valve connector (A). ...

Temperature Control Actuator Replacement
[Driver's side] 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body -& ...

Brake Switch Inspection
1. Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in an ...

Copyright © www.kifomanual.com 2014-2020